Home › Forums › Open-Source Software › CoovaAP Firmware

Unable to change UAMPORT on Ubiquiti Picostation M2

Thu, 06/07/2012 - 09:14 — spliton210

Hi All,

Historical setup means my UAMPORT needs to be set to 3660. I have flashed a new Picostation M2 with the latest firmware, but am unable to get the UAMPORT changed (from stock 3990). I have tried all the usual tricks, host.conf, config, hs.conf, but they ALL get overwritten on reboot. So I thought I would re-write the source file in usr/etc/chilli but they are all read-only.

If I had any hair left I would be pulilng it out ;-) anyone experienced same problem? Know a work-around or solution?

Thanks muchly

Daniel

‹ WAP54G Is this project Dead? ›
Sun, 06/10/2012 - 19:13 — 4DData

Re:Unable to change UAMPORT on Ubiquiti Picostation M2

Hi Daniel,

If you add your changes to the etc/chilli/config as normal then exit.
If you then paste the below syntax it should force chiili to apply your changes.

/etc/init.d/chilli start && /etc/init.d/chilli stop # = apply the config /etc/chilli/config
If you type this in it will allow you to see what is going on if you ssh to the router chilli --debug --fg

Kind regards

Seb

Fri, 09/14/2012 - 07:15 — karloska

I'm running Openwrt with

I'm running Openwrt with Coova and I can't find where the 'original' config file is.

After a reboot etc/chilli/config is rewritten too from somewhere even when using the above (which works untill a reboot)

Anyone know what other files are overwriting etc/chilli/config ?

At the top of etc/chilli/config it states #### This conf file was written by etc-init.d-chilliconf

Which I assumed was etc/ini.d/chilli.conf... no such file though...

Wed, 06/20/2012 - 03:38 — karloska

Is this using the firmware

Is this using the firmware talked about here?

http://www.coova.org/node/5147